Toro Groundsmaster 360 Service Manual page 231

Installing the Manifold (continued)
Groundsmaster 360
16225SL Rev C
3. Remove the caps and plugs from the hydraulic lines and fittings.
4. Lubricate and install new O-rings on the control manifold fittings.
5. Use the labels that you attached during the manifold removal to correctly
connect the hydraulic hoses and tubes to the control manifold; refer to
Installing the Hydraulic Hose and Tube (O-Ring Face Seal Fitting) (page
6. Connect the wire harness connector(s) to the solenoid coil(s) on the manifold.
7. Check the hydraulic-fluid level in the hydraulic reservoir and add correct
quantity of fluid if necessary; refer to the Operator's Manual.
Page 4–173 Hydraulic System: Service and Repairs
4–8).