Brake Cables - Toro Groundsmaster 360 Service Manual

Brake Cables

g036982
1. Operator platform bracket
2. Cable tie
3. Cable tie
4. Cable tie
5. Brake cable (2 each)
Removing the Brake Cable
Chassis: Service and Repairs
6. Brake cable bracket (left)
7. Bolt (2 each per bracket)
8. Clevis pin
9. Brake return spring
10. Return spring bracket
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, and remove the key from the key switch. Ensure that the parking
brake is not applied.
2. Block the wheels with chocks to prevent the machine from moving.
3. Disconnect the brake cable (item 1 in
machine as follows:
A. Remove the return spring (item 6 in
the brake cable to the brake actuator lever.
B. Loosen 1 of the flange nuts (item 2 in
cable to the brake cable bracket.
Figure 265
11.
12.
13.
14.
Figure
Figure
Figure
Page 6–20
Brake assembly (left)
Rear wheel (left)
Bolt (2 each per bracket)
Deck lift shaft
266) from the rear of the
266) and clevis pin that secure
266) that secures the brake
Groundsmaster 360
16225SL Rev C