Air Conditioning Switch (Machines With Operator Cab) - Toro Groundsmaster 360 Service Manual

Air Conditioning Switch (Machines with Operator Cab)

Testing the Air Conditioning Switch
Groundsmaster 360
16225SL Rev C
g037937
1. Cab headliner (air/heat panel)
g037938
The air conditioning switch controls the operation of the air conditioning system.
The switch is located in the cab headliner
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. To access the switch, remove the roof panel from the top of the cab; refer to
Roof Assembly (page
3. Remove the air/heat panel from the cab headliner.
4. Disconnect the wire harness electrical connector from the air conditioning
switch.
5. The air conditioning switch terminals are identified in
circuitry of the switch is shown in the
the use of a multimeter (ohms setting), test the switch functions to determine
if continuity exists between the various terminals for each switch position.
Check the continuity between the switch terminals.
Figure 216
2. Air conditioning switch
Figure 217
(Figure
8–10).
Circuit Logic Table (page
Page 5–73 Electrical System: Testing the Electrical Components
216).
Figure 217 and the
5–74). With