Assembling the Transmission (continued)
Hydraulic System: Service and Repairs
32. Lubricate the flushing valves with clean hydraulic fluid and place them in
the center case bores.
Note: Ensure that you place the right and left flushing valves in the correct
location.
33. Lubricate new O-rings and install the O-rings onto the 2 flushing valve plugs.
Install the springs and plugs to secure the flushing valves; torque the plugs to
23 to 26 N∙m (17 to 19 ft-lb).
g033432
1.
Bypass valve
2.
Center case
3.
Reverse relief cartridge
g033433
1.
Forward relief cartridge
2.
Reverse relief cartridge
34. Lubricate the O-rings and back-up rings for bypass valves. Position the rings
on the bypass valves and install the valves into the center case; torque the
valves to 7 to 9 N∙m (62 to 79 in-lb).
35. Lubricate the sealing washers and install them onto the forward and reverse
relief valve cartridges.
Figure 121
4.
Forward relief cartridge
5.
Valve plate
Figure 122
3.
Hex head groove
Page 4–122
Groundsmaster 360
16225SL Rev C