Toro Groundsmaster 360 Service Manual page 125

Test Procedure (continued)
Groundsmaster 360
16225SL Rev C
A. If the cutting deck is still suspended after 2 hours and lift cylinder rod
movement is less than 31.7 mm (1.25 inch), consider that the lift cylinder
is in good condition.
Note: A lift cylinder in good, usable condition will show minimal rod
movement.
B. If the rod movement is more than 31.7 mm (1.25 inch) after 2 hours,
indicates a lift cylinder with internal seal damage or excessive internal
wear. Replace or repair the lift cylinder; refer to
and Servicing the Lift Cylinder (page
9. Once the lift cylinder condition is determined, use a jack to raise both sides of
the cutting deck slightly which removes the load from the lift cylinder.
10. Support both sides of the cutting deck with jack stands.
11. Remove the cap from the cylinder fitting and the plug from the hydraulic hose.
12. Connect the hydraulic hose to the lift cylinder fitting.
13. Remove the tape from the lift cylinder rod.
14. Remove the jack stands from the cutting deck.
15. Start the engine and operate the lift cylinder through several raise and lower
cycles. Shut off the engine and check for any leakage.
16. Check the hydraulic-fluid level in the hydraulic reservoir.
4–168).
Page 4–67 Hydraulic System: Testing the Hydraulic System
Lift Cylinder (page 4–165)