Aligning the Wheels (continued)
Chassis: Adjustments
g037246
1.
Steering fork (rear)
2.
Outer tie rod end
12. Once the wheel alignment adjustment is correct for both sides of the machine:
A. Check the steering home sensor alignment and adjust as necessary;
refer to
Adjusting the Steering Home Sensor (page
B. Remove the alignment tools from the front and rear steering components.
C. Ensure that the hydraulic hoses on the front steering cylinder are properly
tightened.
D. Install the front cover to the front axle
E. Lower the machine to the ground.
Figure 260
3.
Jam nut
4.
Inner tie rod end
(Figure
Page 6–12
5–47).
255).
Groundsmaster 360
16225SL Rev C