Toro Groundsmaster 360 Service Manual page 396

4-wheel drive models with yanmar engine

Hide thumbs Also See for Groundsmaster 360:

Table of Contents

Removing the PTO Driveshaft

Chassis: Service and Repairs

Note: The PTO driveshaft removal is easier if the machine is positioned on

1. Park the machine on a level surface, lower the cutting deck, shut off the

engine, set the parking brake, and remove the key from the key switch.

Do not start the engine and engage the PTO switch when the PTO

driveshaft is disconnected from the cutting deck. If you start the

engine and the PTO shaft is allowed to rotate, serious personal injury

and machine damage could result.

Before disconnecting the PTO driveshaft from the cutting deck,

disconnect the PTO solenoid coil connector from the wire harness to

prevent the PTO clutch from engaging unintentionally.

Transmission

Coil connector

Solenoid valve and coil

Groundsmaster 360

16225SL Rev C

Chapters

Table of Contents