Using The Engine-Speed Switch; Adjusting The Mowing Speed; Adjusting The Transport Speed - Toro 30609 Operator's Manual

•
Perform a recovery-regeneration whenever
there is a loss of engine power and a parked
regeneration cannot effectively clean the DPF of
soot.
•
A recovery regeneration requires up to 4 hours
to complete.
•
You need a distributor technician to perform the
recovery regeneration process; contact your
Authorized Toro Distributor.
Using the Engine-Speed
Switch
The engine speed switch has 2 modes to change the
engine speed. By momentarily tapping the switch,
the engine speed can be increased or decreased in
100-rpm increments. By holding the switch down, the
engine will automatically move to H
depending on which side of the switch you press.
Adjusting the Mowing
Speed
Supervisor (Protected Menu)
Allows the supervisor to set the maximum mowing
speed, in increments of 50%, 75% or 100%, at which
the operator can mow (low range).
Refer to
the procedure to set the mow speed.
Operator
Allows the operator to adjust the maximum mowing
speed (low range), within the supervisors pre-adjusted
settings. When in the InfoCenter splash or main
screen, press the middle button (
the speed.
or L , Note:
IGH OW IDLE
the settings will transfer based on the previous setting.
The settings are reset when the machine is turned off.
Note:
with cruise control.
Adjusting the Transport
Speed
Supervisor (Protected Menu)
Allows the supervisor to set the maximum transport
speed, in increments of 50%, 75% or 100%, at which
the operator can transport (high range).
Refer to
the procedure to set the transport speed.
Operator
Allows the operator to adjust the maximum
transport speed (high range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash
or main screen, press the middle button (
to adjust the speed.
Note:
the settings will transfer based on the previous setting.
The settings are reset when the machine is turned off.
Note:
with cruise control.
43
Using the InfoCenter Control (page 18)
When switching between low and high ranges,
This feature may also be used in conjunction
Using the InfoCenter Control (page 18)
When switching between low and high ranges,
This feature may also be used in conjunction
for
icon) to adjust
for
icon)