Slave Cylinder; Removal/Lnstallation - Honda Civic Service Manual

Slave Gylinder
Removal/lnstallation
CAUTION:
. Do not spill brake tluid on the vehicle; it may damage
the paint; if brake fluid does contact th€ paint, wash
it off immodiatoly with water,
. Plug the end ot the clutch line with a shop towel to
prevsnt brake fluid from coming oul.
- 6 1 ' s r p " ,
H i g h T e m p U r e a c r e a s e ( p / N
08798 - 90021.
: Brake Assembly Lube or equivalent rubber
grease.
1. Disconnect the clutch line from the slave cvlinder.
2. Remove the slave cylinder from the clutch housing.
12-6
3 . I n s t a l l t h e s l a v e c y l i n d e r i n t h e r e v e r s e o r d e r o f
removal.
NOTE: Make sure the boot is installed on the slave
cvlinder.
.
CLUTCH LINE
15 N.m (1 .5 kgf.m, 1 1 lbf.It)
SLAVE CYLINDER
-G4
(P/N 08798- 90021
8 x 1 . 2 5 m m
22 N.m 12.2 kgl.n,
16 lbl.lt)
:^.
.:i!!!!!
:l
(Brak€ Assembly
Lubol
Bleed the clutch hydraulic system.
a Attach a hose to the bleeder screw, and suspend
the hose in a container of brake fluid.
.
Make sure there is an adequate supply of fluid at
the clutch master cylinder, then slowly pump the
clutch pedal until no more bubbles appear at the
bleeder hose.
. Refill the clutch master cylinder with fluid when
done.
. Always use Genuine Honda DOT 3 Brake Fluid.
Using a non-Honda brake fluid can cause corro-
sion and decrease the life of the system.
. Confirm clutch operation, and check for leaking
flu id.