Honda Civic Service Manual page 668

Countershaft:
1. Bend the tab on the lock washer down, then remove
the bolt and bearing retainer plate.
BEARING RETAINER PLATE
cLutcH tlouslNG
Remove the needle bearing using the special tools
as shown, then remove the oil guide plate'
3/8' - 16 SLIOE HAMMER
(CommerciallY
available)
^
LOCK WASHER
g
Reolace.
d---""-
t
ADJUSTABLE BEARING
PULLER,25 - {o mm
07736 - Aolmo A
3.
Position the oil guide plate and new needle bearing
in the bore of the ctutch housing, then drive in the
needle bearing using the special tools as shown
NOTE: Position the needle bearing with the oil hole
facing up.
NEEDLE
OIL HOLE
NEEDLE
BEARING
Install the bearing retainer plate and new lock wash-
er, then bend the tab against the bolt head'
8 x 1 0 m m
15 N'm (1.5 kgt'm, rl |bt'ft)
LOCK
WASHER
Replace.
13-47