Slave Cylinder Replacement - Honda Accord 2008 Manual

07/11/02 09:15:15 61TA0000_120_0013
9. Install the master cylinder mounting nuts (A).
＊１０
A
8 x 1.25 mm
13 N·m
(1.3 kgf·m,
9.4 lbf·ft)
B
(Multipurpose
Grease)
10. Apply grease to the pedal pin (B), and slide it into
the yoke, then install a lock pin (C).
11. Adjust the clutch pedal, clutch pedal position
switch, and clutch interlock switch (see page 12-7).
12. Bleed the clutch hydraulic system (see page 12-6).
13. Check the clutch operation, and check for leaks.
14. Test-drive the vehicle.

Slave Cylinder Replacement

NOTE:
• Use fender covers to avoid damaging painted
surfaces.
• Do not spill brake fluid on the vehicle; it may damage
the paint or plastic. If brake fluid does contact the
C
paint or plastic, wash it off immediately with water.
1. Do the battery removal procedure (see page 22-90).
A
8 x 1.25 mm
2. Remove the mounting bolts (A), the bracket
13 N·m
(1.3 kgf·m,
mounting nut (B), and the slave cylinder (C).
9.4 lbf·ft)
A
C
B
ＴＡ０８ＡＥＡＥ３４１１６３１７０８１ＫＢＡＴ００
＊０２
(cont'd)
12-11 12-11