Honda Civic Service Manual page 596

Mainshaft Assembly
I
lndex
Note the following during reassembly:
. The 3rd/4th and sth svnchro hubs are installed with a press
. Install the angular ball bearing with the thin-edge outer race facing the sth synchro hub
. Install the ball bearing with the ball cage facing up
prior to reassembling, clean all the parts in solvent, dry them and apply lubricant to all contact surfaces the 3rd/4th
and sth svnchro hubs.
Ballcage faces uP.
Thin edge of outer
race laces down.
3RD/4TH SYNCHRO SLEEVE
page 13'27
SYNCHRO SPRING
SYNCHRO RING
Inspection,
p a g e 1 3 - 2 8
BALL BEARING {*1)
ANGULAR BALL BEARING ('2)
Check for wear and operataon.
Note the direction ot installation
5TH SYNCHRO
SLEEVE
lnspection, page 13-27
SYNCHRO HUB
SYNCHRO RING
Inspection, pase 13 28
sTH GEAR
I n s p e c t i o n ,
p a g e 1 3 - 1 7
3RD GEAR
lnspection, page 1 3-1 6
34 x 39 x 27.5 mm
NEEDLE BEARING
Check for wear
ano opetaflon,
MAINSHAFT
I n s p e c t i o n , p a g e 1 3 - 1 8
CHAMFEB
3 2 x 3 7 x 2 3 . 5 m m
NEEDLE BEARING
Check for wear and
operation.
SPACER COLLAB
I n s p e c t i o n , p a g e 1 3 1 6
3 4 x 3 9 x 2 3 m m
NEEDLE EEARING
Check for wear
and operation,
4TH GEAR
rnspeclron,
*1: D16Y7 engine
*2: D16Y5, D16Y8 engines
p a g e 1 3 ' 1 6
RING
Inspectaon, page 13 28
SPRING
1 3 - 1 5