Honda Civic Service Manual page 914

Troubleshooting Procedures
(cont'd)
C. lf the inspection for a particular code requires voltage or resistance checks at the TCM or PCM connectors, remove
the driver's side kick panel, and unbolt the TCM, and at the PCM connectors, remove the passenger's side kick
panel, and unbolt the PCM. Turn the ignition switch OFF, and connect the backprobe sets and a digital multimeter
as described below. Check the system according to the procedure described for the appropriate code(s) listed on
the following pages.
6 x 1 . 0 m m
9.9 N.m {1.0 kgt m,
How to use lhe Backprob€ SE{
Connect the backprobe adapters to the stacking patch cords, and connect the cords to a multimeter, Using the wire
insulation as a guide for the contoured tip of the backprobe adapter, gently slide the tip into the connector from the
wire side until comes in contact with the terminal end of the wire.
BACI(PROBE SET
07saz - 001 txtoa
Itwo requirodl
DIGITAL MULTIMETER
(Commarcially avsibblel
K S - A H M - 3 2 - ( x ) 3 ,
or oquivalent
6 x 'l,0 mm
9.E N.m (1.0 kgf.m,
7.2 rbtftt
coRo
14-236
ADAPTER