Honda Civic Service Manual page 978

1996-2000
Hide thumbs Also See for Civic:
Table of Contents

Advertisement

Pressure Testing
. While testing, be careful of the rot8ling front wheels.
. M8k6 suro lifts, iacks, and satety stands are placed properly lsee section 11.
CAUTION:
. Before testing, be sur. the transmb3ion fluid is fillod to the propor lcvel.
. Warm up the engin€ to nolmal operating tsmperature bofore testing
. While t€sting, be 3ure not to allow dust and other loreign particles to onler into the transmi$ion.
1. Raise the front of the vehicle, and support it with safety stands (see section 1).
2.
Set the parking brake. and block both rear wheels securely.
3.
Allow the front wheels to rotate freely.
4. Warm up the engine (the radiator fan comes on), then stop arid connect a tachometer.
5. Connect the special tool to each inspection hole.
TOROUE: 18 N.m (1.8 kgt'm, 13 tbtfr)
GAUTION:
. Connect the oil pressuro gauge !!€curoly, bs sur6 not to allow dust and other foroign particlG3 to ontar the inspsc-
tion hole.
. Whon troubleshooting by tho E indicltor light indic.t6
a problam. you mu3t u3e an oil p.essure gluge that moa,
sures 4,9(X) kPa (a.90 MPa,50.0 kS cr*,771psi) or more when molsuring driv. pulley pressure and driven pullcy
pre33ure.
NOTE:
. D.ive pulley pressure may be above 3,430 kPa (3.i8 MPa,35.0 kgf/cmr, 498 psi) wh€n there is a transmission prob-
lem that causes the TCM or PCM to go into the fail-safe mode,
.
Use a commercially available oil pressure gauge that measures 4,900 kPa {4.90 MPa, 5O.O kgf/cmr, 711 psi) or
more, and the Ay'T Oil Pressure Hose, 2210 mm (07MAJ - PY4011A).
FORWARD CLUTCH PRESSURE
INSPECTION
lMarked with
"F")
REVERSE BRAKE PRESSURE
INSPECTION I.IOLE
A/T OIL PRESSURE
GAUGE
SET W/PANEL
0ta{r6 - oO2Oi|(Xt
A/T LOW PRESSURE
GAUGE W/PANEL
0706 - qt7o:t{ro
DRIVE PULLEY PRESSURE
INSPECTION HOI.E
(Marked with "DR")
A/T PRESSURE HOSE
ADAPTER
07MAJ - PYar'120
lil R.qulr.d)
A/T PRESSUBE HOSE
2210 mm
07MAJ - PYitollA
la R.quir.d)
(
INSPECNON HOLE
(Marked with "SC")
CLUICH PRESSURE
INSPECTION HOLE
(Marked with "LUB")
DRIVEN PULLEY PRESSURE
INSPECTION HOLE
lMarked with "DN")
14-3 0 0
ATF DIPSTICK

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents