Oil Seals - Honda Civic Service Manual

Oil Seals
lnstallation
NOTE:
. Engine removal is not required.
. The crankshaft oil seal housing should be dry.
Apply a light coat of grease to the crankshaft and to
the lips of the seals.
1 . U s i n g t h e s p e c i a l t o o l , d r i v e i n t h e t i m i n g p u l l e y -
e n d s e a l u n t i l t h e d r i v e r b o t t o m s a g a i n s t t h e o i l
p u m p .
When the seal is in place, clean any excess grease
off the crankshaft and check that the oil seal lip is
not distorted.
07947 -S800200
lnstall seal with the
part number sade
facing out.
I
2.
Measure the flvwheel-end seal thickness and the oil
seal housing depth. Using the special tool. drive the
flywheel-end seal into the rear cover to the point
where the clearance between the bottom of the oil
seal and the right side cover is 0.5 - 0.8 mm (0.02
-
0.03 in) (see page 7-23).
NOTE: Align the hole in the driver attachment with
the Din on the crankshaft.
DRIVER ATTACHMENT
0794a-s800101
lnslall seal with the
part number side
facing out.
DRIVER
07749-0010000
7 -29