Honda Civic Service Manual page 847

Differential
Diff erential Carrier Replacement
L
Remove the final driven gear from the differential
carrier.
NOTE: The final driven gear bolts have left-hand
threads.
Pry the snap ring off differential carrier, then remove
the speedometer drive gear and 5 x 10 mm roller.
SNAP RING
3. Install the 5 x l0 mm roller in the differential carrier,
Install the speedometer drive gear with its cham-
fered side facing the carrier. Align the cutout on the
bore of the speedometer drive gear with the 5 x 10
mm roller.
14-168,
5. Align the hooked end of the snap ring with the pin-
ion shaft as shown, then install the snap ring in the
differential carrier groovs.
SNAP RING
Hooked end Install in this direction.
SPNI G PIN
Install the final driven gear, then tighten the bolts to
the specified torque.
TOROUE: 101 N.m (10.3 kgf'm, 74.5 lbf.ftl
NOTE: The final driven gear bolts have left-hand
threads.
BOLTS
1 0 r 1 . O m m
1Ol t{.m 11O.3 kgf.m,
74.5 lbl.frl
Left-hand rhreads
FINAL DRIVEN
GEAR
lnstall in this
d i r e c t i o n .
DIFFERENTIAL
CARRIER
7.
Install a new ball bearing (se€ page 14-157).
Install in this direclon.