Honda Civic Service Manual page 196

5.
lnstall the camshafts and camshaft oil seals.
NOTE:
. lnstallthe camshafts with the keyway facing up.
.
lnstall the oil seal withthespring side facing in.
. The oil seal housing surface should be dry'
. Set the O-ring and dowel pin in the oil passage
of the No, 3 camshaft holder'
CAMSHAFT
OIL SEAL
Replace.
Apply liquid gasket (P/N 08718 - 0001 or 08718
-
0OO3) to the head mating surfaces of the No. 1 and
N o . 5 c a m s h a f t h o l d e r s o n b o t h t h e i n t a k e a n d
exhaust side.
NOTE: Clean and dry the cylinder head mating sur-
faces before applying liquid gasket.
- Apply liquid gasket to the shaded areas'
7-
lnstall the camshaft holders and camshaft holder
plaIe.
NOTE: The arrows marked on the camshaft holders
should point to the timing belt.
Tighten each bolt two turns at a time in the sequence
shown below.
NOTE: Wipe off the excess liquid gasket from the No.
1 and No. 5 camshaft holders with a shop towel
(D - @: 8 x 1.25 mm 27 N.|n (2.8 ksf'm, 20 lbf'ft)
Apply ongine oil to the throads.
O - O: 6 x 1.0 mm 9.8 N'm (1.0 kgfrm, 7.2 lbf'ft)
INTAKE
( D o
o o
o o o
EXHAUST
lnstall the back cover and camshaft pulleys.
{cont'd)
o
o
o o
0
o
@
CAMSHAFT
6-85