Honda Civic Service Manual page 865

Transmission
Installation {cont'd)
Connect the lock-up control solenoid connector. and
install the transmission ground cable.
6 x '1.0 mm
12 N.m {1.2 kgf.m, 8.7 lbl.ft}
LOCK.UP CONTROL
SOLENOID CONNECTOR
Connect the staner cables on the staner motor. and
install the cable holder.
NOTE; When installing the starter cable terminal.
make sure that the crimped side of the ring terminal
is facing out (see section 23).
6 x 1 . 0 m m
12 N.m 11.2 kg{.m.8.7 tbtftl
{0.9 kg'f.m, 7 lbf.ftl
TRANSMISSION
GROUND CABLE
14-186
STARTER CAELE
24. Installthe intake air duct.
D16Y7 engine:
Install the intake air duct and the resonaror.
D16Y8 engine:
lnstall the intake air duct and the air cleaner hous_
ang assembly.
25. Refill the transmission with ATF (see page 14_1.18).
26. Connect the positive (+) cable first. then the nega-
tive (-) cable to the battery.
27. Check the ignition timing (see section 23).
28. Start the engine. Set the parking brake, and shift the
transmission through all gears. three times. Check
the shift cable adjustment (see page 14_190).
29, Check the front wheel alignment (see section 1g).
3 0 . L e t t h e e n g i n e r e a c h o p e r a t i n g t e m p e r a t u r e ( t h e
cooling fan comes on) with the transmission in N
or @ position, then turn it off and check the fluid
level (see page 14- 7).
31. Road test as described on pages 14-113 thru ,14_116.