Honda Civic Service Manual page 1021

Transmission
Reassembly (cont'd)
53. Verify that the outside diameter of the snap ring is
correct.
M a x i m u m 2 6 . 3 m m ( 1 . 0 4 i n )
54.
SNAP RING
Measure the clearance between the 22 x 28 mm
thrust shim and the snap ring.
STANDARD: 0.37 - 0.65 mm (0.015 - 0.026 inl
NOTE: Take measurements in at least three places,
and use the average as the actual clearance.
lf the clearance is out of tolerance, remove the 22 x
28 mm thrust shim and measure its thickness.
Select and install a new 22 x 28 mm thrust shim,
then recheck.
THRUST SHIM, 22 x 28 mm
55.
c o .
No. Part Numb€r
Thicknsss
c
9 0 5 7 3 - P 4 V - 0 0 0
1 . 1 5 m m ( 0 . 0 , { 5 i n )
D
9 0 5 7 4 - P 4 V - 0 0 0 1.40 mm {0.055 in)
E 9 0 5 7 5 - P 4 V - 0 0 0 1.65 mm (0.065 in)
F
9 0 5 7 6 - P 4 V - 0 0 0 1.90 mm (0.075 in)
9 0 5 7 7 - P 4 V - 0 0 0 2 . 1 5 m m ( 0 . 0 8 5 i n )
9 0 5 7 8 - P 4 V - 0 0 0 2.40 mm (0.095 in)
14-344
INPUT SXAFT
After replacing the 22 x 28 mm thrust shim. make
sure that the clearance is within tolerance and the
snap ring outside diameter is correcr.
Install the pitot flange using its cutout as shown to
clear the pitot pipes.
Install the ATF pump drive sprocket. and put the
ATF pump drive chain on the ATF pump drive and
driven sprockets, then install 8nd tighten the bolts
(three bolts).
TF PUMP DRIVE CHAIN
58.
59.
6 x 1 . 0 m m
12 N.m
11.2 kg{.m,8.7 lbf.ftl
ATF PUMP ORIVE
SPROCKET
PITOT FLANGE
ATF PUMP