Honda Civic Service Manual page 1017

Transmission
1 6 .
Reassembly (cont'dl
2 1 .
1 7 .
lf the clearance is not within the standard, remove the
reverse brake end plate and measure its thickness.
Select and install a new reverse brake end Dlate.
then recheck.
N O T E : l f t h e t h i c k e s t r e v e r s e b r a k e e n d o l a t e i s
installed, but the clearance is still over the standard,
replace the reverse brake discs and plates.
REVERSE BRAKE END PLATE
After replacing the reverse brake end plate, make
sure that the clearance is within the standard.
R e m o v e t h e s n a p r i n g , r e v e r s e b r a k e e n d p l a t e ,
discs, plates. and disc spring.
I n s t a l l t h e s n a p r i n g r e t a i n e r o n t h e d r i v e p u l l e y
shaft.
Wrap the drive pulley shaft splines with tape to pre-
v e n t d a m a g e t o t h e O - r i n g s , t h e n i n s t a l l n e w O -
n n g s .
Install the forward clutch assembly on the drive pul-
ley shaft, then installthe snap ring.
SITAP
O-RINGS
1 8 .
1 9 .
20.
SI{AP RIM;
BETA EB
DRIVE PUI.IEY
SHAFT
Plat6 No.
Part Number
Thickness
1
22551 - P4V - 003 3 . 6 m m ( 0 . 1 4 2 i n )
22552-P4V-003 3 . 8 m m ( 0 . 1 5 0 i n )
2 2 5 5 3 - P 4 V - 0 0 3 4 . 0 m m ( 0 . 1 5 7 i n )
4 2 2 5 5 4 - P 4 V - 0 0 3 4 . 2 m m ( 0 . 1 6 5 i n )
5 2 2 5 5 5 - P 4 V - 0 0 3 4 . 4 m m ( 0 . 1 7 3 i n )
6 2 2 5 5 6 - P 4 V - 0 0 3 4 . 6 m m ( 0 . 1 8 1 i n )
7
22557 -P4V -OO3 4 . 8 m m ( 0 . 1 8 9 i n )
8 2 2 5 5 8 - P 4 V - 0 0 3 5.0 mm (0.200 in)
14-340
25. Installthe carrier assembly on the forward clutch.
22. Verity that the outside diameter ol the snap ring is
correct.
SI{AP RIiIG
Install the input shaft and the sun gear as a sub
assemDry.
I n s t a l l t h e t h . u s t n e e d l e b e a r i n g a n d t h e t h r u s t
washer on the sun gear.
CARRIER ASSEMBLY
THFUST I'IEEDI!
EEARIT{G
Msximum 41.4 mm 11.63 in)
IHruST