Camshafts - Honda Civic Service Manual

Camshafts
Inspection
NOTE:
. Do not rotate the camshaft during inspection.
. Removg the rocker arms and rocker shafts.
'L
Put the camshafts and camshaft holders on the cylin-
der head. and then tighten the bolts to the specified
torque.
Specified Torque:
O -@: 8 mm botts 27 N.m {2.8 kgf.m,20 lbt'ft)
Apply engine oil to the threads,
O - @: 6 mm bolts 9.8 N.m (1.0 kgf m, 7.2 lbf'ft)
Seat the camshaft by pushing it toward the distribu-
tor end of the cylinder head.
Zero the dial indicator against the end of the distrib-
utor drive. then push the camshaft back and fonh
and read the end play.
Camshaft End Play:
Standard {New}: 0.05 - 0.15 mm
{0.002 - 0.006 inl
Service limil:
0.5 mm (0.02 in)
o
o
o
o o
o o
o o
o
o o
\-
4 .
Remove the bolts. then remove the camshaft hold-
ers from the cylinder head.
-
Lift the camshaft out of the cylinder head, wipe
c l e a n , t h e n i n s p e c t t h e l i f t r a m p s . R e p l a c e t h e
camshaft if lobes are pitted, scored, or excessively
- Clean the camshaft bearing surfaces in the cylin
der head, then set the camshaft back in place,
-
Insert a plastigage strip across each iournal.
Put the camshaft on the cylinder head. then install
the camshaft holders, and then tighten the bolts to
the specified torque as shown in the left column on
this page.
R e m o v e t h e c a m s h a f t h o l d e r s , t h e n m e a s u r e t h e
widest portion of the plastigage on each journal.
Camshaft -to-Hold€1 Oil Clearsnce:
Standard {Newl: 0.050 - 0.089 mm
{0.002 - 0.004 inl
S6rvice Limit:
0.15 mm 10,006 inl
(cont'd)
6- 7 5
PLASTIGAGE STRIP