Honda Civic Service Manual page 853

Transmission Housing Bearings
L
Mainshaft/Countershaft Bearings Replacement
To remove the mainshaft and countershaft bearings
from the transmission housing, expand each snap
ring with snap ring pliers, then push the bearing out
using the special tools and a press as shown.
N O T E : D o n o t r e m o v e t h e s n a p r i n g s u n l e s s i t ' s
necessary to clean the grooves in the housing.
DRIVER
07749 - 0010000
ATTACHMENT,
6 2 x 6 8 m m
PRESS
\
07746 -
DFIVEB
07749 - 0010000
TTACHMENT
ATTACHMENT
. Mainshaft Bearing Installation us€:
ATTACHMENT. 72 x 75 mm
07746 - 0010600
. Countershaft Bearing Installation use:
ATTACHMENT, 62 x 68 mm
077/16 - 0010500
IRN
{L{r.)n
\bZ
MAINSHAFT BEARING
1 4 - 1 7 4
SNAP RING
Expand each snap ring with snap ring pliers, insert
t h e n e w b e a r i n g p a r t - w a y i n t o t h e h o u s i n g u s i n g
the special tools and a press as shown, Install the
bearing with the groove facing outside the housing.
NOTE: Coat all parts with ATF.
Release the pliers, then push the bearing down into
the housing until the ring snaps in place around it.
07749 - 0010000
ATTACHMENT
. Mainshaft Bearing Removal use:
ATTACHMENT, 72 x 75 mm
077/16 - 0010600
. Counte6haft Bsaring Removal use:
ATTACHMENT, 62 x 68 mm
07746 - 0010500
After installing the bearing verify the following:
. The snap ring is seated in the bearing and hous-
ing grooves.
. The ring end gap is correct.
(0 - 0.28 in)
E N D G A P : 0 - 7 m m