Final Driven Gear Replacement; Bearing Replacement - Honda Civic Service Manual

r l a
Final Driven Gear Replacement
'1. Remove the bolts in a crisscross pattern in several
steps, and remove the final driven gear from the dif-
ferential carrier.
N O T E : T h e f i n a l d r i v e n g e a r b o l t s h a v e l e f t - h a n d
threads,
12 x 1.0 mm
101 N.m {'10.3 kgf.m,74.5 lbf.ftl
Left hand
FINAL DRIVEN GEAR
Chamfer on inside daameter of
final driven gear faces carrier.
2.
Install the final driven gear by tightening the bolts
in a crisscross pattern in several steps.
NOTE: Drive the bearings squarely until they bot-
tom against the carrier.
BALL BEARING
1 3 - 8 3
Bearing Replacement
NOTE: Check the ball bearings for wear and rough rota-
tion. lf bearings are OK, removal is not necessary.
1. Remove the ball bearings using a standard bearing
puller and bearing separator as shown.
BEARING PULLER
BEARING SEPARATOR
lCommercially
availab16)
BALL BEARING
2 .
I n s t a l l n e w b a l l b e a r i n g s u s i n g t h e s p e c i a l t o o l a s
shown.