Honda Civic Service Manual page 204

lllustrated Index
(cont'd)
NOTE: New rod bearings must be selected by matching connecting rod
assembly and crankshaft
( s e e p a g e 7 , 1 1 ) .
identification markings
Lubricate all internal parts with engine oil during
reassembtv.
PISTON INSTALLATION DIRECTION:
EXHAUST
4\/=\6\z\
\e/!rqrf/
INTAKE
PISTON RINGS
Replacement. page 7-20
Measurement, pages 7 20 andj-21
Alignment, page 7-21
PISTON PIN
Removal, page 7,17
Installation, page 7-18
Inspection, page 7,19
CONNECTING ROD
End play, page 7-8
Selection, page 7,18
CONNECTING ROD
BEARINGS
C l e a r a n c e , p a g e 7 1 1
S e l e c t i o n , p a g e 7 - 1 1
CONNECTING ROD BEARING CAP
Installation, page 7-23
NOTE: lnstall caps so the
bearing recess is on the
same side as the recess
in the rod.
PISTON
Inspectron, page 7-15
NOTE: Betore removing the piston, inspect the
top of the cylinder bore for carbon build-up or
ridge. Bemove ridge if necessary, page 7-13
ENGINE BLOCK
Cylinder bore inspection, page 7-16
Warpage inspection, page 7,'16
Cylinder bore honing, page 7,17
Inspect top of each cylinder bore
for carbon build-up or ridge
before removing piston.
Remove ridge if necessary, page 7-13
CONNECTING ROD CAP NUT
816A2 €ngin6:
9 x 0.75 mm
{0 N.m (4.1 kgt m, 30 tbf.ftl
D16Y5, Dl6Y7. D16Y8 engines:
8 x 0.75 mm
3l N.m {3.2 kg{.m,
23 tbt.fr)
Apply engine oilto
the bolt threads.
NOTE: After torquing each bearing
cap, rotate crankshaft to
check for binding.
7-6