Honda Civic Service Manual page 192

7.
Apply a thin coat of clean engine oil to the outside
of the new valve guide. Install the guide from the
camshaft side of the head; use the special tool to
drive the guide in to the specified installed height. lf
you have all l6 guides to do, you may have to reheat
t h e h e a d ,
VALVE GUIDE DRIVER,
5.5 mm
077i12 - (x)l01(x)
tr
A\
Valve Guide Installed Hoight:
lntake: 12.55 - 13.05 mm {0.,194 - 0.514 in)
Exhaust: 12.55 - 13.05 mm 10.494 - 0.51'l in)
VALVE GUIDE
\
Reaming
NOTE: For new valve guides onlY.
1. Coat both reamer and valve guide with cufting oil.
2.
Rotate the reamer clockwise the full length of the
valve guide bore.
C o n t i n u e t o r o t a t e t h e r e a m e r c l o c k w i s e w h i l e
removing it from the bore
Thoroughly wash the guide in detergent and water
to remove any cutting residue.
Check clearance with a valve lsee page 6-73)
. V e r i f y t h a t t h e v a l v e s l i d e s i n t h e i n t a k e a n d
exhaust valve guides without exertlng pressure.
REAMER HANDLE
Turn r6amer in
clockwise direction
a
VALVE GUIOE REAMER. 5.5 mm
OTHAH - PJTO1IIB
6- 8 1