Honda Civic Service Manual page 156

Valves
Camshaft/Rocker Arms and
Camshaft Seal/Pulley
Installation (cont'd)
4 . I n s t a l l t h e v a l v e s p r i n g a n d v a l v e r e t a i n e r . t h e n
install the valve spring compressor. Compress the
spring and installthe valve keepers.
NOTE: Place the end of the valve spring with close-
ly wound coils toward the cylinder head.
lCornmercially
available)
Snap-on CFrll or KD - 3tX'
with #32 JAWS
Lightly tap the end of each valve stem two or three
times with a plastic mallet to ensure proper seating
of the valve and valve keepers.
NOTE: Tap the valve stem only along its axis so you
do not bend the stem.
' 6-44
Installation
CAUTION:
. Make sure that all tockers are in alignment with their
valvgs when torquing the rocket assembly bolts,
. Valve locknuls should be loosened and adiusting
screws backed off bofore installation.
. To prevont tho rocker arm a$smbly from coming
apad, l6av€ the camshaft holder bohs in the holdeB.
1. After wiping down the camshaft, camshaft seal and
j o u r n a l s i n t h e c y l i n d e r h e a d , l u b r i c a t e b o t h s u r -
faces and install the camshaft.
2.
Clean and install the oil control orifice with a new
O-ring.
CAMSHAFT SEAL
Seal housing surface should be dry.
Apply a light coat of oil to camshaft
a n d i n n e r l i p o f s e a l .
3.
Turn the camshaft until its keyway is facing up (No.
piston TDC).
OIL CONTROL ORIFICE