Release Bearing; Removal/Lnspection - Honda Civic Service Manual

Release Bearing
)
4. Torque the mounting bolts in a crisscross pattern as
s h o w n . T i g h t e n t h e m i n s e v e r a l s t e p s t o p r e v e n t
warping the diaPhragm sPring.
19 rbf.ft)
\
RING GEAR HOLDER
oTLAB-PV00100
o t
07924-PD20003
CLUTCH ALIGNMENT SHAFT
OTJAF_PM7O12A
HANOLE
0 7 9 3 6 - 3 7 1 0 1 0 0
MOUNTING BOLTS
8 x 1 . 2 5 m m
25 N.m (2.6 kgl'm.
Removal/lnspection
1. Remove the release fork boot from the clutch hous-
I n g .
2.
Remove the release fork from the clutch housing by
squeezing the release fork set spring with pliers
Remove the release bearing.
Check the release bearing for play by spinning it by
h a n d .
CAUTION: The releass bearing is packed with
grease. Do not wash it in solvent.
lf there is excessive play, replace the release bear-
ing with a new one.
RELEASE FORK
12-11