Honda Civic Service Manual page 1012

Transmission Housing Bearings
Driven Pulley Shaft Bearing Replacement
1. To remove the driven pulley shaft b'earing trom the
t r a n s m i s s i o n h o u s i n g , e x p a n d t h e s n a p r i n g w i t h
s n a p r i n g p l i e r s , t h e n p u s h t h e b e a r i n g o u t u s i n g
the specialtools and a press as shown.
NOTE: Do not remove the snap ring unless it's nec-
essary to clean the groove in the housing.
07749 - 001(xDo
ATTACHMENT,
7 2 x 7 5 m m
07746 - (x'l05U)
077i() - 001(xrco
14-334
SNAP RING
Expand the snap ring with snap ring pliers, insert
the new bearing part-way into the housing using
the special tools and a press as shown. Install the
bearing with the groove facing outside the housing.
N O T E : C o a t a l l p a n s w i t h C W F l u i d .
R e l e a s e t h e p l i e r s , t h e n u s i n g t h e s p e c i a l t o o l s ,
push the bearing down into the housing until the
snap ring snaps in place.
BEARING
ATTACHMENT,
7 2 x 7 5 m m
07746 - OO1 0600
GROOVE
SNAP RING
After installing the bearing verify the following:
o The snap ring is seated in the bearing and hous-
ing grooves.
. The ring end gap is correct.
END GAP| 0 -9 mm
l0 - 0.35 inl