Honda Civic Service Manual page 599

Mainshaft Assembly
Disassembly (cont'd)
3.
Support the 3rd gear on steel blocks, and press the
mainshaft out of the 3rd/4th synchro hub as shown.
1 3 - 1 8
Inspection
' 1 . I n s p e c t
t h e g e a r s u r f a c e a n d b e a r i n g s u r f a c e f o r
wear and damage. then measure the mainshaft at
points A, B, C, and D.
Siandard:
A: 21.987 - 22.000 mm
10.8656 - 0.8661 inl
B: 26.980 - 26.993 mm
11.0622 - 1.0627 inl
C: 33.98,1- 34.000 mm
(1.3380 - 1.3385 in)
D: 25.977 - 25.990 mm
|.1.0227 - 1.0232 inl
Service Limit: A: 21.930 mm 10.8634 inl
B: 26.930 mm {1.0602 in}
C: 33.930 mm (1.3358 in)
D: 25.920 mm (1.0205 in)
Check for wear and damage
lf any part of the mainshaft is less than the service
limit, replace it with a new one.
2. Inspect for runout.
Standardi
0.02 mm (o.(Xtl in) max.
S€rvice Limii: 0.05 mm (0.002 in)
N O T E : S u p p o r t t h e m a i n s h a f t a t b o t h e n d s a s
snown.
lf the runout is more than the service lirnit, reolace
the mainshaft with a new one.
Y