Honda Civic Service Manual page 863

Transmission
Installation (cont'dl
9. Attach the torque converter to the drive plate with
eight drive plate bolts and torque as follows:
Rotate the crankshaft pulley as necessary to tighten
the bolts to 1/2 of the specified torque. then to the
final torque, in a crisscross pattern.
After tightening the last bolt, check that the crank-
shaft rotates freely.
TOROUE: 12 N.m {1.2 kgl.m, 8.7 tbt{r}
10 x 1.25 mm
6 x 1 . 0 m m
12 N.m (1.2 kgt m,
8.7 rbt ft)
I \ 1.25 mm
2/t N.m {2.4 kg{.m,
17 tbt ftl
CONVERTEB
10. Install the torque convener cover and the €ngine
stiffener.
'11. Tighten
the crsnkshaft pull€y bolt, if necessary (see
section 61.
12. Connect the ATF cooler hoses to the ATF cooler lines
(see page 1,t192).
ATF COOIIR
UNE
10 x 1.25 mm
a,l N.m {4.5 kgl.m,
33 rbt.ftt
RIGHT FRONT
12 x 1.25 mm
MOUNT/BRACKET 6.t N.m (6.5 kg{.m,
47 tbt ftl
13. Install the right front mounvbracket.
4,r N.m 14.5 kgf.m,33 lbtft)
COVER
14-1A4
SHIFT CABLE
SHIFT CAAE COVER
14. Install the control lever with a new lock washer to
the control shaft, then install the shift cable cover.
CAUION: Taks care not to bend the shift cable.
L(rcK WASHER
Replace.
8 x 1,25 r'|m
22N-m
12.2 tgt m. 16lbnftl
x 1.0 mm
tit N.m 11.4 kgt m,
10 tbr,ft,
15. lnstall the exhaust pipe A.
NOTE: D16Y8 engine is shown; D16y/ engine is sim_
ilar.
Replace.
GASKET
Replace.
SELF.LOCKING NUT
Replace.
10 x 1.25 mm
54 N.m (5.5 lgf.m,
40 tbt ftl
NUT
SELF.LOCKING NUT
Replace.
8 x 1.25 mm
22 N.m {2.2 kgl.m, 16lbtfrl
Replace.
8 x 1.25 mm
16 N.m {1.6 kgI.m,
12 tbf.ft)