Honda Civic Service Manual page 1020

44. Push the handle of the special tool, then tighten the
nut to seal the secondary drive gear assembly on
the driven pulleY shaft securelY.
STAAT CLUTCH Ii'ISTALIIR
07TAE - PaV0130
OF
46.
SHAFT HA'{DI,-E
Pull the handle of the special tool up, and remove
the special tool.
lnstallthe cotters, then measure the clearance Delween
the cotters and the start clutch guide
STANDARD: 0 - 0.13 mm (0 - 0.005 inl
NOTE: Take measurements in at least three places,
and use the average as the actual clearance
GAUGE
lil
(il
COTTERS, 25.5 mm
START 1
GAUGC
START CLUTCH
14-343
47.
48.
lf the clearance is not within the standard, remove
the cotters and measure their thickness
Select and install new cotters, then recheck.
COTTERS, 25.5 mm
After replacing the 25.5 mm cotters, make sure that
the clearance is the standard
lnstall the cotter retainer and the snap rlng
Verify that the outside diameter of the snap ring is
correct.
Minimum 33.9 mm (1.33 in)
SNAP RII{G
l n s t a l l t h e t h r u s t w a s h e r s . t h e A T F p u m p d r r v e
sprocket hub and the 22 x 28 mm thrust shim on the
inDUt shaft, then install the snap ring.
49.
50.
52.
THRUST WASXERS
INPUT SHAFT
(cont'd)
No.
Part Number
Thickness
9 0 4 2 9 - P 4 V - 0 0 0 2.9 m m
( 0 . 1 1 4 i n )
B
9 0 4 3 0 - P 4 V - 0 0 0 3.0
m m ( 0 . 1 1 8 i n )
c
9 0 4 3 1 - P 4 V - 0 0 0 3 . 1 m m ( 0 . 1 2 2 l n )
D
9 0 4 3 2 - P 4 V - 0 0 0 3 . 2 m m ( 0 . 1 2 6 i n )
SNAPRING\
ATF PUMP DRIVE
SPROCKET HUB
THFUST SHIM, 22 x 2a mm
Selective pan