Lnstallation - Honda Civic Service Manual

Rocker Arms
lnstallation
1 .
2 .
3 .
l n s t a l l t h e r o c k e r a r m s i n t h e r e v e r s e o r d e r o f
removal:
. Valve adjusting locknuts should be loosened and
the adiusting screw, backed off before installa-
t r o n .
. The component parts must be reinstalled in the
original locations.
lnstall the lost motion assemblies.
l n s t a l l t h e r o c k e r a r m s w h i l e i n s e r t i n g t h e r o c k e r
arm shaft into the cylinder head
NOTE: Remove the rubber band after installing the
rocker arms.
12 mm BOLT
\
6-83
4. Clean and install the rocker shaft orifices with new
O - r i n g s . l f t h e h o l e s i n t h e r o c k e r a r m s h a f t a n d
cylinder head are not in line with each other, screw
a 12 mm bolt into the rocker arm shaft and rotate
the shaft.
NOTE: The shapes of the rocker shaft orifices tor
the intake and exhaust are different. The orific'
must be installed in the proper locations.
INTAKE ROCKER
SHAFT ORIFICE
EXHAUST ROCKER Clean
SHAFT ORIFICE
O.RING
O