Pressure Plate - Honda Civic Service Manual

Pressure Plate
\
Removal/lnsPection
1 . Inspect the fingers of the diaphragm spring for wear
at the release bearing contact area.
Check the diaphragm spring fingers for height using
the special tools and a feeler gauge.
Standard {New}: 0.6 mm (0.02 inl max.
Seruice Limit:
1.0 mm {0.04 in}
FEELER GAUGE
CLUTCH ALIGNMENT DISC
OTJAF_PM7O1 1A
CLUTCH ALIGNMENT SHAFT
OTJAF-PM7012A
HANDLE
07936-37tOtOO
lf the height exceeds the service limit, replace the
pressure Plate.
3.
Installthe special tools
PRESSURE PLATE
MOUNTING
BOLT
ALIGNMENT SHAFT
OTJAF-PM7012A
HANDLE
0 7 9 3 6 - 3 7 1 0 1 0 O
o7924-PD20003
GEAR HOLDER
07LA8-PVOOIOO
ot
ENGINE
BLOCK
ADJUSTER BOLT
BOLT
4. To prevent warping, unscrew the pressure plate
m o u n t i n g b o l t s i n a c r i s s c r o s s p a t t e r n i n s e v e r a l
steps, then remove the pressure plate.
\ r f
1 2 - 7
lnspect the pressure plate surface for wear' cracks,
a n d b u r n i n g .
Inspect for warpage using a straight edge and leeler
g a u g e .
NOTEr Measure across the pressure plate at three
pornrs.
Standard (Newl: 0.03 mm (0.001 inl max.
Service Limit:
0.15 mm (0.006 inl
lf the warpage exceeds the service limit, replace the
pressure plate.
STBAIGHT EDGE