Honda Civic Service Manual page 516

Intake Air System
Throttle Cable (cont'dl
4 . S e t t h e l o c k n u t o n t h e c a b l e b r a c k e t . A d j u s t t h e
adjusting nut so that its free play is O mm.
5. Bemove the cable sheath from the throttle bracket,
reset the adjusting nut and tighten the locknut.
O16Y5, D16Y8 engino:
ADJUSTING NUT
9.8 N.m
{1.0 kgl.m,
1.2 tbt.ttl
DtGYT 6ngine:
11-246
816A2 engine:
1. Open the throttle valve fully, then install the throttle
c a b l e i n t h e t h r o t t l e l i n k a g e . a n d i n s t a l l t h e c a b l e
housing in the cable bracket,
THROTTLE LINK
LOCKNUT
ADJUSTING
NUT
Start the engine. Hold the engine at 3.000 rpm with
n o l o a d ( i n P a r k o r n e u t r a l ) u n t i l t h e r a d i a t o r f a n
comes on, then let it idle.
H o l d t h e t h r o t t l e l i n k t o t h e t h r o t t l e l e v e r ; t h e r e
should be no clearance.
Hold the cable sheath, removing all slack from the
cable.
Turn the adjusting nut untit it is 3 mm {1/8 in.) away
from the cable bracket,
LOCKNUT
9.8 N.m
(1.0 kgt m,
7.2 tM.ttl
ADJUSTING NUT
T i g h t e n t h e l o c k n u t . T h e c a b l e d e f l e c t i o n s h o u l d
n o w b e 1 0 - 1 2 m m l 3 / B - 1 / 2 i n . ) . l f n o r . s e e
Inspection/Adjustment.
3 mm 11/8 in.)