Slave Cylinder; Removal - Honda Prelude 1993 Service Manual

Slave Cylinder
Removal
Disconnect the clutch pipe from th€ slave cylinder.
CAUTION: Avoid spilling braks tluid on the paintod
3u.facos, as it may damago th€ tinish.
NOTE: Plug the end of the res€rvoir hose, and cap
the end of the clutch pipe, with a plug and cap such
as those discarded from an IVC kit.
Remove the slave cylinder from the clutch housing.
Relhov€ and chock tor signs of leaking
and deterioration.
lnstallation
-6ll,
Super High Temp LJrea Grease (P/N 08798 -
9002).
: Brake Assembly Lube or equivalent rubber
grease.
1 . Install the slave cylinder on the clutch housing.
Connect the clutch pipe.
CLUTCH PIPE
15 N'm {1.5 kg-m.
SLAVE CYUNDER
BLEEOER SCREW
10 N{n (1,0 kg-m,
7 tb-ft|
8 x 1,25 mm
22 N.m {2.2 kg-m,
16 tb-ft|
(Braks Assembly
Lub6)
3. Bleed the ciutch hydraulic system:
Attach a hose to the bleeder screw and suspend
the hose in a container of brake fluid.
Make sure there is an adequate supply of fluid at
the master cylinder, then slowly pump the clutch
pedal until no more bubbles appear at the bleed-
er hose.
Refill the master cvlinder fluid when done.
Use onlv DOT 3 or 4 brake fluid.
-#,1
(P/N 08798 -
a
a
l ,
CLUTCH PIPE
BOOT
12-6