Inspection Using Special Tools - Honda Civic Service Manual

Remove the cylinder head cover.
NOTE: Refer to page 6-88 when installing the cylin-
der head cover.
Push the mid rocker arm on the No. 1 cylinder man-
ually.
Check that the mid rocker arm moves independently
of the primary and secondary rocker arms.
Check the mid rocker arm ot each cylinder at TDC'
.
lf the mid rocker arm does not move, removs the
mid, primary and secondary rocker arms as an
assembly and check that the pistons in the mid
and primary rocker arms move smoothly.
.
lf any rocker arm needs replacing, replace the
primary. mid, and secondary rocker arms as an
assembly.
7 .
2.
Plug the
per).
Inspection Using SPecial Tools
CAUTION:
.
B€fore using tho Yalvo inspeciion tool, mako suro
that ths air pre3sure gauge on the air comprossor
indicatos ovor /rco kPa (,1 kgf/cm', 57 psi)
. In3poct ths valve closranca bafore rock$ arm impoc'
tion.
. Cover the timing beh whh I shop towel to prcvenl
gstting oil on the bolt'
. Chock ths mid rocker arm of each cylindll at TDC'
1.
Remove the cYlinder head cover.
NOTE: Rsfer to page 6-86 when installing the cylin-
der head cover.
relief hole with the special tool (Air Stop-
OTLA' - PRSO2OA
3.
Remove the bolt and washer from the inspection
hole and connoct the an air pressure regulator with
a 0 - 100 psi gauge.
AIF STOPPEB
TNSPECTION HOIE
OTLA' - PR3O2OA
t0 x 1.0 mrn
20 N.m {2.0 kgf m,
14 tbt'fr)
AIR PRESSURE
REGULATOR
{Cornm.rcirlly avril.bl.l
BEGULATOR VALVE
. Pull the lever and
turn to adjust.
{cont'd}
6- 55