Honda Civic Service Manual page 647

Shift Fork Assembly
Clearance Inspection
NOTE: The synchro sleeve and the synchro hub should
be replaced as a set.
1. Measure the clearance between each shift fork and
its matching synchro sleeve.
Standard:
0.35 - 0.65 mm {O.Olit - 0.026 inl
Service Limit: 1.0 mm t0.04 inl
SHIFT FOBK
lf the clearance is more than the service limit. mea_
sure the thickness of the shitt fork finoers.
Standard: 7.4 - 7.6 mm (0.291 - 0.299 in)
l f t h e t h i c k n e s s o f t h e s h i f t f o r k f r n g e r s r s n o t
within the standard, replace the shift fork with a
new one.
lf the thickness of the shift fork fingers is within
the standard, replace the synchro sleeve with a
1 3 - 6 6
3.
Measure the clearance between the shift piece and
the shift fork shafts.
Standard:
0.2 - 0.5 mm (0.008 - 0.02 inl
Service Limit: 0.8 mm {0.03 in)
lf the clearance is more than the service limit. mea-
sure the width of the shift Diece.
Standard: 11.9 - 12.0 mm (0.469 - 0.it72 in)
lf the width of the shift piece is not within the
standard, replace the shift piece with a new one.
lf the width of the shift piece is within the stan_
dard, replace the shift fork with a new one.
t ,
SHIFT PIECE