Honda Civic Service Manual page 787

Mai nshaft/Cou ntershaft
Linear Solenoid Assembly
Speed Sensors
Replacement
1. Remove the mounting bolts and the linear solenoid
assemory.
Clean the mounting surface
and flu id passages.
6 x 1 . 0 m m
12 N.m 11.2 kgl m,
8.7 tbf.ftl
@
@
GASKET
Clean the mounting surface and fluid passage of the
linear solenoid assembly and transmission housing.
Install a new linear solenoid assembly with a new
gasl(et.
NOTE; Do not pinch the gasket when installing the
linear solenoid; make sure that the gasket is installed
properly in the mounting groove of the linear sole-
noid.
Check the linear solenoid connector for rust, dirt or
oil, and connect it securely,
LINEAR
SOLENOID
ASSEMELY
14-108
Replacement
't.
6 x
1 2
8.7
Remove the 6 mm bolt and the countershaft speed
sensor from the right side cover.
COUNTERSI{AFT
SPEED SENSOR
O.RING
Replace.
MAINSHAFT
SPEED
SENSOR
MAINSHAFT SPEED
SENSOB WAS}IER
(D16Y7 enginel
6 x 1 . 0 m m
12 N.m (1.2 kgf m,
8.7 tbf.ft)
1 . 0 m m
N.m (1.2 kgf.m,
rbf ft)
\
\
\ / ,
% / E : )
Remove the 6 mm bolt and the mainshaft sDeed
sensor from the transmission housino.
Replace the O-ring with a new one before installing
the countershaft speed sensor or th€ mainshaft speed
sensor.
NOTE: Installthe mainshaft speed sensor washer on
the mainshaft speed sensor. The mainshaft speed
sensor washer is used on models with the D'|6Y7
engine.