Honda Civic Service Manual page 997

l .
1 .
2.
Remove the end cover {three 6 mm bolts, eleven 8
mm bolts).
Remove the manualvalve body lines A and B
3. Remove the snap ring securing the ring gear, then
remove the thrust shim and the ring gear'
4. Remove the snap ring securing the reverse brake
discs and plates, then remove the reverse brake end
plate. brake discs, brake plates, and disc spring'
5. Remove the carrier with the thrust washers and the
thrust needle bearing from the forward clutch
6. Remove the sun gear and the input shaft as a sub
assembly bY Pulling it
The sun gear is press fitted tightly into input shaft'
7. Remove the snap ring securing the forward clutch,
and remove the snap ring securing the forward clutch
end plate, then remove the forward clutch end plate'
8 . R e i n s t a l l t h e c a r r i e r o n t h e f o r w a r d c l u t c h , t h e n
secure the carrier with the snap ring on the forward
clutch end Plate.
9. Remove the forward clutch and carrier assembly
together.
' 1 0 . l n s t a l l t h e s p e c i a l t o o l t o r e m o v e t h e s n a p r i n g
securing the reverse brake return spring retainer as
snown.
REVERSE BBAKE
SPRING COMPRESSOR
07TAE - PaV0110
11. Compress the return springs. then remove the snap
ring
C A U T I O N : l f t h e s p r i n g r e t a i n e r t a b i s o n t h e
rsverse braks piston, tho spting letainer may be
damaged. Be surs the spring letainer tab is not on
the piston.
SPfiING FETAIiGR
TAB
Remove the special tool, then remove the spring
retainer/return spring assembly.
Remove the sealing bolt securing the reverse brake
pressure insPection hole.
Apply air pressure to the inspection hole to remove
the reverse brake Piston
12.
1 3 .
1 4 .
1 6 .
't7
SPBING REYAINER/
RETURiI SPRIiIG
ASSEMALY
REVERSE BNAXE
PISTON
o-Rrllcs
Replace.
FCVERSE BRAKE
PRESSURE INS?ECTK)N
HOtl
SEALING
WASHER
Replace.
8 x 1.25 mm
18 N.m 11.8 kgf.m, 13 lbf.ttl
Remove the snap ring retainer from the drive pulley
shaft.
Remove the manual valve body (five bolts)'
Remove the roller and push the control shaft assem-
bly toward the outside of the transmission housing,
then remove the intermediate housing (four bolts)'
SPECIAL TOOL
14-319