Honda Civic Service Manual page 100

13. Remove the throftle cable by loosening the locknut,
then slip the cable end out of the accelerator link-
a g e .
NOTE;
. Take care not to bend the cable when removing
it. Always replace any kinked cable with a new
one.
. Adjust the throttle cable when installing (see sec-
t i o n 1 1 ) .
D16Y7 engine:
D16Y5, D16Y8, B16A2 engines:
LOCKNUT
LOCKNUT
1 4 , Disconnect the connectors from the PCM.
R e m o v e t h e g r o m m e t a n d w i r e h a r n e s s c l a m p s ,
then pull out the ECM/PCM connectors
6 x 1 . 0 m m
16. Remove the mounting bolt and lock bolt, then remove
the power steering (P/S) pump belt and pump
NOTE: Do not disconnect the P/S hoses.
816A2 engine:
Remove the adjusting bolt and mounting boits,
then remove the P/S pump belt and pump
(cont'd)
5- 5
AOJUSTING