Adiustment; Timing Belt; Mark - Honda Civic Service Manual

Timing Belt
lnstallation (cont'dl
3. Install the timing belt tightly in the sequence shown.
@ T i m i n g b e l t d r i v e p u l l e y ( c r a n k s h a f t ) + @
Adjusting pulley * @ Water pump pu ey + @ Intake
camshaft pulley + @ Exhaust camshaft pulley,
NOTE: Make sure the timing belt drive pulley and
camshaft pullevs are at TDC,
Loosen and retighten the adjusting bolt to tension
the timing belt.
Install the lower cover and middle cover.
NOTE: Clean the middle and lower covers before
installing.
Install the crankshaft pulley, then tighten the pulley
bolt (see page 459).
Rotate the crankshaft pulley about five or six turns
counterclockwise so that the timing belt positions on
the pulleys.
Adjust the timing belt tension (see page A611.
7 .
6-64
a
9. Check that the crankshaft pulley and camshaft pul-
leys are both at TDC.
CRANKSHAFT PULLEY
CAMSHAFT PULLEY:
lf the camshaft and crankshaft pulleys are not posi-
tioned at TDC, remove the timing belt, adjust the
position following the procedure on page &63, then
reinstall the timing belt.
After installation, adjust the tension of each belt.
. See section 23 for alternator belt tension adjust-
ment.
. See section 22lor NC compressor belt tension
adiustment,
. See section 17 for P/S pump belt tension adjust-
ment.
' l
1 0 .
1 1 .
I
"UP" MARKS