Honda Civic Service Manual page 173

Timing Belt
Removal
NOTE:
.
Replace the timing belt at 105,000 mites (168,000 km)
according to the maintenance schedule (normal con-
ditions/severe conditions).
lf the vehicle is regularly driven in one or more of the
following conditions, replace the timing belt at 60,OOO
miles (U.S.A.) 100,000 km {Canada).
. In very high temperatures (over 110"F, 43"C).
. In very low temperatures (under -20.F, 29.C).
. Turn the crankshaft pulley so the No. 1 piston is at
top dead center (TDC) before removing the belt (see
page 6-57).
. Inspect the water pump before installing the timing
belt {see page 10-14).
1 .
IOLER PULLEY BRACKET
EOLT
10 x 1.25 mm
44 N.m 14.5 kgf.m, 33 bnft)
6-62
Remove the splash shield (see page 5-9).
Remove the adjusting bolt and mounting bolts, then
r e m o v e t h e p o w e r s t e e r i n g ( P / S ) p u m p b e l t a n d
p u m p .
8 x L 2 5 m m
24 N m {2.{ kgf.m, 17 lbf.ft)
Loosen the idler pulley bracket bolt and adjusting bolt,
then remove the air conditioning (A,/C) compressor
belt
aDJUsnNG
44 N.m 14.5 kgt.m, 33 lbf.ft)
P/S PUMP LOWER ARACKET
a
\
4. Loosen the mounting nut and lock bolt, then remove
the alternator belt.
LOCK BOLT
8 x 1.25 mm
24 N.m {2.4 kgt.m.
17 rb{.ftl
5. Remove the upper bracket (see page 6-69).
NOTE:
. Use a jack to support the engine before removing
the upper bracket.
o Place a cushion between the oil pan and the jack.
Remove the P/S pump lower bracket
8 x 1.25 mm
24 N.m 12.,1 kgf.m,
17 tbf.ftl
l 0 x 1 . 2 5 m m
' - f
MOUNTING
10 x 1.25 mm
44 N.m (4.5 kgf.m.
33 rbf.ftt
BELT
HEAT SHIELD