Honda Civic Service Manual page 849

Differential
Oil Seal Installation/Side Clearance (cont'd)
4. Tap on the transmission housing side of the differ-
ential assembly with the special tool to seat the dif-
ferential assembly in the torque converter housing.
DRIVER 40 mm l.D.
14-170
5.
N4easure the clearance between the 80 mm set ring
and outer race of the ball bearino in the transmis-
s i o n h o u s i n g .
STANDARD: 0 - 0.15 mm (0 - 0.006 inl
SET RING, 80 mm
BALL BEARING
lf the clearance is more than the standard, select a
new set ring from the table, and install:
SET RING, 80 mm
NOTE: lf the clearance measured in step 5 is stan-
dard, it is not necessary to perform steps 7 and 8.
Remove the transmission housing.
Replace the 2.50 mm (0.098 in) 80 mm set ring with
the one of the correct thickness selected in step 6.
7 .
Part Number Thickness
9 0 4 1 4 - 6 8 9 - 0 0 0
9 0 4 r 5 - 6 8 9 - 0 0 0
9 0 4 1 6 - 6 8 9 - 0 0 0
9 0 4 1 7 - 6 8 9 - 0 0 0
9 0 4 1 8 - 6 8 9 - 0 0 0
9 0 4 r 9 - P H 8 - 0 0 0
2.50 mm (0.098 in)
2 . 6 0 m m { 0 . 1 0 2 i n )
2 . 7 0 m m { 0 . 1 0 6 i n )
2 . 8 0 m m ( 0 . 1 1 0 i n )
2 . 9 0 m m ( 0 . 1 1 4 i n )
3 . 0 0 m m ( 0 . 1 1 8 i n )