Honda Civic Service Manual page 111

Engine Removal/lnstallation
Installation (cont'd)
Except CVT:
12 x 1.25 mm
64 N.m (6.5 kgd.m,
Tighten the bolts/nut on the left front mount in the
numbered sequence shown {O - @).
( t 1 2 x 1 . 2 5 m m
8 3 N ' m ( 8 . 5 k g f . m , 6 1 t b t . t r l
/+4 N.m 14.5 kgf.m,
33 lbt.trl
O 1 2 r 1 . 2 5 m m
59 N.m 16.0 kgt.m,
43 tbt.rtl
S e p l a c e .
5 - 1 6
\
7. Perform the following:
. Clean the areas where the driveshaft(s) and the
intermediate shaft contact the transmission (dif_
ferential) thoroughly with solvent or carburetor
cteaner, and dry with compressed air.
. Check that the set rings on the ends of the drive_
shaft and intermediate shaft click into place.
CAUTION: Use new set rings,
. Adjust the shift cable (see section 14).
. Adjust the throttle cable (see section 11).
. Adjust the cruise control cable (see section 23).
. Refill the engine with engine oil (see page 8-6).
. Refill the transmission with fluid (see section 13,
1 4 ) .
.
Refill the radiator with engine coolant (see page
10-7).
.
Bleed air from the cooling system with the heater
valve open (see page j0-7).
. Clean the battery posts and cable terminals with
sandpaper, assemble them, then apply grease to
prevent corrosaon.
. Inspect for fuel leakage (see section j l).
After assembling the fuel line, turn on l) the igni_
tion switch (do not operate the starter) so that the
fuel pump runs for approximately two seconds
and the fuel line pressurizes. Repeat this opera_
taon two or three times, then check for fuel leak_
age at any point in the fuel line,