Honda Civic Service Manual page 994

Transmission Housing/Flywheel Housing
Removal
NOTE:
. Cleanall parts thoroughly in solvent or carburetor cleaner, and dry with
compressed air.
.
Blow out all passages.
. When removing the transmission housing/flywheel housing, replace the following:
- O-rings
-
Secondary drive gear assembly
- Sta rt clutch assemblv
-
Flywheel housing gasket
ATF PASSAGE LINE
HOLD€R ASSEMBLY
IX)WEL PIN
OIFFERENTIAL ASSEMBLY
SNAP RING
COTTER RETAINER
COTTERS, 25.5 mm
Selective part
8 x 125 mm BOLT
O.RING
Rsplaco.
VWHEEL HOUSING
EYWIIEEL HOUSING GASKET
Roolace.
START CLUTCH
ASSEMBLY
Replace.
ATF PA$gAGE
UNE ASSEMBLY
6 x 1,0 mm BOLT
O.RING
Replace.
ATF PUMP DRIVE CHAIN
SNAP RING
THRUST SHIM,
2 5 x 3 5 m m
Seloctive part
SECONDARY
GEAR SHAFT
SECONDARY DRIVE
GEAR ASSEMBLY
Replace.
PARK
PAWL SHAFT
THRUST SHIM, 22 r 28 mm
Seloctive part
GRII{GS
Replac€.
6 x 1.0 mm BOIT
ATF PUMP DRIVE
SPROCKET
PfTOT FLANGE
ATF PUMP DRTVE
SPROC|(ET HUB
THRUST WASHERS
PARK PAWL
SPRING
INPUT SHAFT
14-316
DRIVEN PULLEY SHAFT
InANSMISS|O]{ HOUSTNG