Honda Civic Service Manual page 1027

Transmission
1 7 .
Installation (cont'd)
Install I new set ring on the end of each driveshaft.
Install the right and left driveshafts (see section 16).
CAUTION: While instatling the drive3hafts in the
differential, be sure not to allow dust and olher for-
aign particles to enter into tho transmission.
NOTE:
. Clean the areas where the driveshafts contact the
transmission {differential} thoroughly with sol-
vent or carburetor cleaner, and drv with com-
Dressed air.
. Turn the right and left steering knuckle fully out-
wa.d, and slide each driveshaft into the differen-
tial until you feel its set ring clip engage the side
gear.
Install the damper fork, then install the right and left
ball joints to each lower arm with the castle outs
and new cotter pins.
1 9 .
10 x 1.25 mm
43 N.m
{4.4 kgf.m, 32 lbf.ftl
SELF-LOCKING NUT
Replace.
12 x 1.25 mm
6l N.m
CASTI.I
'12 x 1.25
mm
{6.s ksr.m. 47 tbr.ftr l! _ ll
ffiteo
- s.o tet'.,
14 - 35 0
20. Install the splash shietd.
a
a
I
6
I
6 *
"a,a
s
2 1 .
SECONOARY GEAR
SHAFT SPEED
SENSOB CONNECTOR
6 x 1 . 0 m m
9.8 t{.m 11.0 kgt.m,
7.2 tbf.trl
Connect the vehicle speed senso. connector. the
driven pulley speed sensor connector and the sec-
ondary gear shaft speed sensor connector,
6 x 1 , 0 m m
12 N.m {1.2 kg{.m, 8.7 tbf,ft)
DRIVEN PULLEY
SPEED SENSOR
CONNECTOR
E.
6 x 1.0 m.rl
'12 N.m
{1.2 kg{.m,8.7 tbf.fo