Mitsubishi Electric 800 Series Instruction Manual page 67

 Mounting the operation panel on the enclosure surface
• The operation panel can be used for setting the inverter parameters, monitoring various items, and checking fault
indications.
• Having an operation panel on the enclosure surface is convenient. With a connection cable, the operation panel can be
mounted to the enclosure surface and connected to the inverter. Use the option FR-CB2[ ], or connectors and cables
available on the market. (To mount the operation panel, the optional connector (FR-ADP) is required.) Securely insert one
end of the connection cable until the stoppers are fixed.
NOTE
• Refer to the following table when fabricating the cable on the user side. Keep the total cable length within 20 m.
Name
Communication cable
• For details on the FR-LU08, refer to the FR-LU08 Instruction Manual.
 Communication operation
• Using the PU connector enables communication operation from a personal computer, etc. When the PU connector is
connected with a personal, FA or other computer by a communication cable, a user program can run to monitor the inverter
or read and write parameters. Communication can be performed with the Mitsubishi inverter protocol (computer link
operation). For the details, refer to
66
2. INSTALLATION AND WIRING
2.7 Communication connectors and terminals
Parameter unit connection cable
(FR-CB2[ ]) (option)
Operation panel (FR-LU08)
Operation panel connection connector
(FR-ADP) (option)
Remarks
Cable compliant with EIA-568 (such as 10BASE-T cable)
page 473.