Mitsubishi Electric 800 Series Instruction Manual page 277

Monitor item
Motor load factor 0.1%
Cumulative power 0.01 kWh/
0.1 kWh
Motor output 0.01 kW/0.1
kW
Trace status 1
PLC function user According to
monitor 1 the SD1215
setting
PLC function user
monitor 2
PLC function user
monitor 3
Station number 1
(RS-485 terminals)
Station number 1
(PU)
Station number 1
(CC-Link)
Energy saving Changeable
effect by
parameter
Cumulative energy
setting.
saving
PID set point 0.1%
PID measured 0.1%
value
PID deviation 0.1%
Input terminal —
status
Output terminal —
status
Option input —
*9
terminal status
276
5. PARAMETERS
5.8 (M) Monitor display and monitor output signal
Increment Pr. setting
and unit
24
25
*5*6
34
*6
38
40
41
42
43
44
45
50
51
52
53
54
*17
55
*17
56
RS-485 MODBUS
RTU
H18 40224
H19 40225
H22 40234
H26 40238
H28 40240
H29 40241
H2A 40242
H2B 40243
H2C 40244
H2D 40245
H32 40250
H33 40251
H34 40252
H35 40253
H36 40254
*10 *10
H0F 40215
*11 *11
H10 40216
— —
Negative Description
indication
*1
(-)
Displays the output current value as
a percentage, considering the
inverter rated current value as 100%.
Monitor value = output current
monitor value / inverter rated current
 100 [%]
Displays the cumulative energy
based on the output power monitor.
This can be cleared with Pr.170.
(Refer to page 281.)
Multiplies the output torque at that
time with the motor speed, and
displays the machine output for the
motor shaft end.
Displays the trace status. (Refer to
page 466.)
Displays the arbitrary monitoring
item using the PLC function.
Displays the following special
register values.
SD1216: Displays in No.40
SD1217: Displays in No.41
SD1218: Displays in No.42
(Refer to the PLC Function
Programming Manual.)
Displays which station number (0 to
31) can currently be used for
communication from the RS-485
terminal block.
Displays which station number (0 to
31) can currently be used for
communication from the PU
connector.
Displays which station number (0 to
31) can currently be used for CC-
Link communication.
Displays "0" when the FR-A8NC is
not connected.
Displays the energy saving effect
monitor.
Conversion to power saving,
average power saving, price display,
and percentage display can be done
using parameters.
(Refer to page 291.)
Displays the set point, measured
value, and deviation under PID
control.
(Refer to page 410)

Displays input terminal ON/OFF
state of the inverter. (Refer to the
instruction manual of the operation
panel.)
Displays output terminal ON/OFF
state of the inverter. (Refer to the
instruction manual of the operation
panel.)
Displays input terminal ON/OFF
state of the digital input option (FR-
A8AX) on the DU. (Refer to the
instruction manual of the operation
panel.)