Mitsubishi Electric 800 Series Instruction Manual page 226

 JOG operation in PU
• When the operation panel or the parameter unit is in the JOG operation mode, the motor jogs only while the start button
is pressed. (For the operation method, refer to
NOTE
• The reference frequency of the acceleration/deceleration time differs according to the Pr.29 Acceleration/deceleration
pattern selection setting. (Refer to
• The Pr.15 setting should be equal to or higher than the Pr.13 Starting frequency setting.
• Changing the terminal assignment using Pr.178 to Pr.189 (Input terminal function selection) may affect the other
functions. Set parameters after confirming the function of each terminal.
• During JOG operation, the second acceleration/deceleration cannot be selected with the RT signal. (Other second
functions are enabled. (Refer to
• When the JOGR or STR signal is input while the JOGF signal is input, the motor is decelerated to stop.
• When the JOGF or STF signal is input while the JOGR signal is input, the motor is decelerated to stop.
• The three-wire type connection is not available for the JOGF and JOGR signals.
• When Pr.79 Operation mode selection="4", JOG operation is started by one push of
panel and stopped by
• This function is invalid when Pr.79= "3".
• To perform the JOG operation using the external signals, select the setting of "JOG signal" for the input via terminal JOG
in Pr.291 Pulse train I/O selection. (Refer to
Parameters referred to
page 201
Pr.13 Starting frequency
Pr.20 Acceleration/deceleration reference frequency, Pr.21 Acceleration/deceleration time increments
Pr.29 Acceleration/deceleration pattern selection
Pr.79 Operation mode selection
Pr.178 to Pr.182 (Input terminal function selection)
page 105.)
page 194.)
page 348.))
.
page 222.)
page 194
page 204
page 343
/
5.6 (D) Operation command and frequency command
3
4
5
5
5
on the operation
6
7
8
page 190
9
10
225
5. PARAMETERS