Mitsubishi Electric 800 Series Instruction Manual page 615

Protective/ Protective
warning function
function
Warning
function
Surrounding air
temperature
Surrounding air humidity
Storage temperature
Atmosphere
Altitude/vibration
*1 Available only for the standard model.
*2 This protective function is not available in the initial status.
*3 Temperature applicable for a short time, e.g. in transit.
2
*4 2.9 m/s
614
8. SPECIFICATIONS
8.2 Common specifications
Overcurrent trip during acceleration, Overcurrent trip during constant speed, Overcurrent trip during
deceleration or stop, Regenerative overvoltage trip during acceleration, Regenerative overvoltage trip
during constant speed, Regenerative overvoltage trip during deceleration or stop, Inverter overload trip
(electronic thermal relay function), Motor overload trip (electronic thermal relay function), Heat sink
overheat, Instantaneous power failure
of synchronism detection
(ground) fault overcurrent, Output short circuit, Output phase loss, External thermal relay operation
thermistor operation
circuit board), PU disconnection, Retry count excess
circuit/RS-485 terminals power supply short circuit, 24 VDC power fault, Abnormal output current
*2
detection , Inrush current limit circuit fault
communication fault, Safety circuit fault, Overspeed occurrence
*2
PID signal fault , Internal circuit fault, User definition error in the PLC function, Internal storage device
fault
Fan alarm, Stall prevention (overcurrent), Stall prevention (overvoltage), Electronic thermal relay function
pre-alarm, PU stop, Parameter copy, Maintenance timer 1 to 3
*2
Password locked
Load fault warning, Emergency drive in operation, Continuous operation during communication fault
FR-F860-00090 or lower : -10°C to +40°C (non-freezing) (LD rating), -10°C to +30°C (non-freezing) (SLD
rating)
FR-F860-00170 to 01080 : -10°C to +40°C (non-freezing)
FR-F860-01440 or higher : -10°C to +50°C (non-freezing) (LD rating), -10°C to +40°C (non-freezing) (SLD
rating)
95% RH or less (non-condensing)
*3 -20°C to +65°C
Indoors (without corrosive gas, flammable gas, oil mist, dust and dirt, etc.)
Maximum 2500 m (For the installation at an altitude above 1000 m, consider a 3% reduction in the rated
current per 500 m increase in altitude.), 5.9 m/s
or less for the FR-F860-02890 or higher.
*1
, Undervoltage
*2
, Upper limit fault detection, Lower limit fault detection, Output side earth
*2
, Option fault, Communication option fault, Parameter storage device fault (control
*1
, Communication fault (inverter), Analog input fault, USB
, Parameter write error, Copy operation error, 24 V external power supply operation,
2
or less
*1 *1*2
, Input phase loss , Stall prevention stop, Loss
*2
, CPU fault, Operation panel power supply short
*2 *2
, 4 mA input fault
*2
, USB host error, Operation panel lock
*4
at 10 to 55 Hz (directions of X, Y, Z axes)
*2
, PTC
*2
, Pre-charge fault ,
*2
,
*2